Example For Configuring The Snmp Query Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.35.7 Example for Configuring the SNMP Query Test

Networking Requirements
As shown in
used to measure the time from sending an SNMP query packet to receiving an Echo packet.
Figure 6-9 Networking diagram for configuring the SNMP query test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Enable SNMP agent on Switch C.
<SwitchC> system-view
[SwitchC] snmp-agent
Issue 01 (2012-03-15)
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
Figure 6-9, SNMP agent is enabled on Switch C. The NQA SNMP query test is
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client.
Create and perform the SNMP query test on Switch A.
Enable SNMP agent on Switch C.
Host address of the SNMP agent
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE2/0/0
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
6 NQA Configuration
SwitchC
GE1/0/0
SNMP Agent
395