Huawei S9300 Configuration Manual page 368

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type pwe3trace
The test type is set to PWE3 Trace.
Step 4 (Optional) Run:
vc-type ldp
The method of setting up a PW is configured.
Step 5 (Optional) Run:
local-pw-type { local-pw-type | ip-interworking }
The type of the local PW is configured. By default, the type is Ethernet.
Step 6 Run:
lsp-version { rfc4379 | draft6 | ptn-mode }
A protocol is configured for the LSP test instance.
Step 7 (Optional) Run:
label-type { control-word | label-alert | normal}
The type of the PW label is configured.
Step 8 Run:
local-pw-id local-pw-id
The ID of the local end of the PW is configured.
Step 9 (Optional) Run the following commands to configure other parameters for the PWE3 Trace test:
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure maximum hops of the PWE3 Trace test, run the tracert-hopfailtimes
Issue 01 (2012-03-15)
NOTE
l When label-type is set to control-word, run the remote-pw-id remote-pw-id command to configure
the ID of the remote end of the PW.
l When label-type is set to label-alert, run the destination-address ipv4 ip-address { lsp-masklen
mask-length | lsp-loopback loopback-address }* command to configure the destination IP address of
the PWE3 Trace test.
l When label-type is set to normal, run the destination-address ipv4 ip-address { lsp-masklen mask-
length | lsp-loopback loopback-address }* command to configure the destination IP address of the
PWE3 Trace test.
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
timescommand.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
353