Optional) Adjusting The Performance Of The Nqa Mtrace Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The address of the multicast source is specified.
Step 4 Run:
mtrace-group-address ipv4 ip-address
The multicast group address is specified. Note that the address must be a common group address.
Step 5 (Optional)The VPN instance is specified.
vpn-instance vpn-instance-name
Step 6 Run:
quit
Exit from the test instance view.
----End
6.21.4 (Optional) Adjusting the Performance of the NQA MTrace
Test
This part describes how to set optional MTrace test parameters according to the network
operating status.
Context
Do as follows on the switch with the MTrace test being configured:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
ttl number
The TTL value, that is, the maximum hops traced in max-hop mode is set for the IGMP Tracert-
Request packet.
Step 4 Run:
tracert-livetime first-ttl first-ttl max-ttl max-ttl
The maximum hops traced in hop-by-hop mode is set. first-ttl must be set to 1.
Step 5 Run:
mtrace-response-address ipv4 ip-address [ ttl value ]
The destination IP address and TTL of the IGMP Tracert-Response packet are set.
Issue 01 (2012-03-15)
NOTE
The steps described in this procedure are all optional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
327