Example For Checking The Multicast Path From The Source To The Switch Through The Mtrace Test - Huawei S9300 Configuration Manual

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

6.35.18 Example for Checking the Multicast Path from the Source to

the switch Through the MTrace Test

Networking Requirements

all Switches to make Switches work synchronously, receiver is added to the multicast group

225.1.1.1 and receives multicast data from Source normally. The RTB can receive multicast

data. This test is performed to check how the multicast traffic is transmitted to RTB from Source.

You need to configure an NQA MTrace test on Switch B to implement the MTrace function.

You can check the multicast path from the multicast source to the local Switch.

Figure 6-20 Networking diagram for checking the multicast path from the multicast source to

the local Switch

Issue 01 (2012-03-15)

GigabitEthernet3/0/0

port hybrid pvid vlan 130

port hybrid untagged vlan 130

area 0.0.0.0

network 11.1.0.0 0.0.0.255

network 11.1.1.0 0.0.0.255

network 11.1.26.0 0.0.0.255

6-20, on the PIM-SM multicast network, implement the NTP protocal on

Huawei Proprietary and Confidential

6 NQA Configuration