Huawei S9300 Configuration Manual page 398

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Figure 6-3 Networking diagram for configuring the ICMP test
NQA agent
Configuration Roadmap
The configuration roadmap is as follows:
1.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Create a VLAN and add interfaces to the VLAN.
# Configure Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan 10
[SwitchA-Vlan10] quit
[SwitchA] interface gigabitethernet 1/0/0
[SwitchA-GigabitEthernet1/0/0] port hybrid pvid vlan 10
[SwitchA-GigabitEthernet1/0/0] port hybrid untagged vlan 10
[SwitchA-GigabitEthernet1/0/0] quit
# Configure Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] vlan 10
[SwitchB-Vlan10] quit
[SwitchB] interface gigabitethernet 1/0/0
[SwitchB-GigabitEthernet1/0/0] port hybrid pvid vlan 10
[SwitchB-GigabitEthernet1/0/0] port hybrid untagged vlan 10
[SwitchB-GigabitEthernet1/0/0] quit
Step 2 Configure the VLANIF interface and assign an IP address to the VLANIF interface.
# Configure Switch A.
[SwitchA] interface vlanif 10
[SwitchA-Vlanif10] ip address 10.1.1.1 24
# Configure Switch B.
[SwitchB] interface vlanif 10
[SwitchB-Vlanif10] ip address 10.1.1.2 24
Step 3 Enable the NQA client and create an NQA ICMP test.
Issue 01 (2012-03-15)
SwitchA
GE1/0/0
VLANIF10
10.1.1.1/24
Perform the NQA ICMP test to check whether the route between the local end (Switch A)
and the specified destination end (Switch B) is reachable and check the RTT of a test packet.
Host address of Switch B
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE1/0/0
VLANIF10
10.1.1.2/24
6 NQA Configuration
383