Huawei S9300 Configuration Manual page 423

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure LDP on Switch A, Switch B, and Switch C. (The detailed procedure is not mentioned
here.)
For the configuration of LDP, refer to the S9300&S9300E Terabit Routing Switch Configuration
Guide - MPLS.
Step 3 # Configure Switch A.
# Enable the NQA client and create an LSP Ping test for a common tunnel.
<SwitchA> system-view
[SwitchA] nqa test-instance admin lspping
[SwitchA-nqa-admin-lspping] test-type lspping
[SwitchA-nqa-admin-lspping] lsp-type ipv4
[SwitchA-nqa-admin-lspping] destination-address ipv4 3.3.3.9 lsp-masklen 32
Step 4 Perform the test.
[SwitchA-nqa-admin-lspping] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-lspping] display nqa results test-instance admin lspping
NQA entry(admin, lspping) :testflag is inactive ,testtype is
1 . Test 1 result
----End
Configuration Files
l
Issue 01 (2012-03-15)
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:3.3.3.9
Min/Max/Average Completion Time: 1/1/1
Sum/Square-Sum Completion Time: 3/3
Last Good Probe Time: 2011-2-28 15:32:56.1
Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 100
#
mpls lsr-id 1.1.1.9
mpls
#
mpls ldp
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
mpls
mpls ldp
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface LoopBack1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
6 NQA Configuration
lspping
408