Example For Checking The Rpf Path From The Source To Destination Host Through The Mtrace Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.35.19 Example for Checking the RPF Path from the Source to
Destination Host Through the MTrace Test
Networking Requirements
As shown in
all Switches to make Switches work synchronously, Receiver is added to the multicast group
225.1.1.1 and receives multicast data from Source normally. Switch B is the Switch at the last
hop. This test is performed to check how the traffic is transmitted to Receiver from Source along
the RPF route.
You need to configure an NQA MTrace test on Switch C to implement the MTrace function.
You can check the RPF path from the multicast source to the destination host.
Issue 01 (2012-03-15)
port hybrid pvid vlan 150
port hybrid untagged vlan 150
#
interface GigabitEthernet3/0/0
port hybrid pvid vlan 130
port hybrid untagged vlan 130
#
ospf 1
area 0.0.0.0
network 11.1.0.0 0.0.0.255
network 11.1.1.0 0.0.0.255
network 11.1.2.0 0.0.0.255
#
pim
#
return
Figure 6-21, on the PIM-SM multicast network, implement the NTP protocal on
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
433