Huawei S9300 Configuration Manual page 141

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
[HUAWEI_0.Administrator-1-cluster] display cluster
Cluster name:"HUAWEI"
Role:Administrator switch
Management vlan id
Cluster multicast MAC address : 0180-c200-000a(default)
Cluster auto-join
Handshake timer:10 second(s)
Handshake hold-time:60 second(s)
IP pool:10.0.0.1/8
Logging host:4.0.0.1
SNMP host:3.0.0.1
FTP server:2.0.0.1
SFTP server:2.0.0.2
cluster-member ftp-timeout: 300 second(s)(default)
Cluster SNMP NAT capability : enabled
Cluster FTP NAT capability : enabled
There are 4 member(s) in the cluster, and 0 of them are down.
Step 10 Verify the configuration.
l Member switches access the FTP server in NAT mode.
l A device out of the cluster accesses the FTP server in the cluster in NAT mode.
----End
Configuration Files
l
Issue 01 (2012-03-15)
: 10
: disabled
<HUAWEI_3.Member-3> cluster-ftp
Trying 10.0.0.1 ...
Press CTRL+K to abort
Connected to 10.0.0.1.
220 FTP service ready.
User(10.0.0.1:(none)):hgmp
331 Password required for hgmp.
Enter password:
230 User logged in.
[ftp]
# Configure an FTP server on Member-2. The configuration details see Configuration Files,
and are not mentioned here.
# Calculate the port number reserved for the FTP protocol of a member switch in the cluster.
The member ID of Member-2 is 2. Using the formula for computing port numbers reserved
for a cluster ( Interface number reserved for a cluster = Base interface number + Member
number*2) , you can obtain that the reserved port number, which is used by Member-2 to
enable the FTP server, is 53248 + 2*2 = 53252.
# Run the FTP client program on the PC and set up an FTP connection with Member-2 in
NAT mode.
NOTE
A device out of the cluster accesses the FTP server in the cluster in NAT mode. IP address of the FTP
server is that of the management VLANIF interface on the administrator switch. The FTP server uses
a port number reserved in the cluster instead of the commonly-used 21.
ftp> open 1.0.0.1 53252
Connected to 1.0.0.1.
220 FTP service ready.
User (1.0.0.1:(none)): hgmp
331 Password required for hgmp.
Password:
230 User logged in.
ftp>
Configuration file of Administrator-1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
126