Creating An Nqa Mtrace Test; Configuring The Nqa Mtrace Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.21.2 Creating an NQA MTrace Test

This part describes how to configure an MTrace instance before performing the MTrace test for
the multicast path from the multicast source to the querier.
Context
Do as follows on the switch that functions as the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type mtrace
The test type is set to MTrace.
Step 4 Run:
quit
Exit from the test instance view.
----End

6.21.3 Configuring the NQA MTrace Test

This part describes how to set parameters for the MTrace test for the multicast path from the
multicast source to the querier.
Context
Do as follows on the switch with the NQA MTrace test instance being created:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
mtrace-source-address ipv4 ip-address
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
326