Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The destination IP address is configured.
Step 5 Run:
destination-port port-number
The destination port number is configured.
Step 6 (Optional) Perform the following as required to configure other parameters for the UDP test
( For detailed parameter configurations, see the chapter
Parameters
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the source port number, run the source-port port-numbercommand.
l To configure the interval for sending test packets, run the interval seconds interval
l To configure the percentage of the failed NQA tests, run the fail-percent percent command.
l To configure the NQA test packets to be sent without searching the routing table, run the
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.13.4 Checking the Configuration

After configuring the UDP test, you can view the test result.
Prerequisites
The configurations of the UDP Test function are complete.
Issue 01 (2012-03-15)
):
command.
command.
sendpacket passroute command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Configuring Universal NQA Test
289