Huawei S9300 Configuration Manual page 503

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure BGP/MPLS IP VPN to ensure that the VPN network works normally and unicast
routes are reachable.
For configuration details, refer to the chapter "BGP/MPLS IP VPN Configuration" in the
S9300&S9300E Configuration Guide - VPN.
Step 2 Enable multicast and PIM globally. Packet transmission between PEs and P is multicast
implementation on the public network while packet transmission between the PE and the CE is
multicast implementation in VPN instances.
For configuration details, refer to the chapter "IPv4 Multicast VPN Configuration" in the
S9300&S9300E Configuration Guide - IP Multicast.
Step 3 Configure identical share-group address, MTI, and switch-address-pool range of Switch-MDT
for the same VPN instance on each PE.
For configuration details, refer to the chapter "IPv4 Multicast VPN Configuration" in the
S9300&S9300E Configuration Guide - IP Multicast.
Step 4 Configure the identical share-group address, MTI, and switch-address-pool range of Switch-
MDT for the same VPN instance on each PE.
For configuration details, refer to the chapter "IPv4 Multicast VPN Configuration" in the
S9300&S9300E Configuration Guide - IP Multicast.
Step 5 Configure an NQA Mtrace test instance on Switch B.
<SwitchB> system-view
[SwitchB] nqa test-instance admin mtrace
[SwitchB-nqa-admin-mtrace] test-type mtrace
[SwitchB-nqa-admin-mtrace] mtrace-source-address ipv4 10.0.40.90
[SwitchB-nqa-admin-mtrace] destination-address ipv4 10.0.2.10
[SwitchB-nqa-admin-mtrace] mtrace-query-type last-hop
[SwitchB-nqa-admin-mtrace] vpn-instance red
[SwitchB-nqa-admin-mtrace] mtrace-last-hop-address ipv4 10.0.1.10
Step 6 Start the test.
[SwitchB-nqa-admin-mtrace] start now
Step 7 Verify the configuration.
# Run the display this command on Switch B. You can view the configuration of the test
instance.
<SwitchB> display this
#
Issue 01 (2012-03-15)
Start the NQA Mtrace test instance and verify the test result.
Test instance name: admin mtrace
IP address of the multicast source: 10.0.40.90/24
IP address of the destination host: 10.0.2.10/24
IP address of the last-hop: 10.0.1.10/24
Name of the VPN instance: RED
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
488