Disabling Ntp Service; Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The maximum number of dynamic NTP sessions is set.
----End

4.3.10 Disabling NTP Service

If you do not want to use NTP IPv4 or IPv6 services, run the ntp-service disable command.
This will disable all NTP IPv4 or IPv6 services.
Context
To prevent a device from synchronizing the clock with IPv4 or IPv6 external servers or peers,
you can disable NTP IPv4 or IPv6 service on the device. Also, if it not required to provide the
reference clock source for IPv4 or IPv6 external clients, you can disable NTP IPv4 or IPv6
service.
Do as follows on the switch that needs to be disabled from NTP services.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ntp-service disable
NTP service is disabled on the switch.
By default, NTP service is enabled.
----End

4.3.11 Checking the Configuration

After basic NTP functions are configured, you can view the configuration.
Prerequisites
The configurations of the Basic NTP Functions are complete.
Procedure
l
l
l
l
----End
Issue 01 (2012-03-15)
Run the display ntp-service status command to view the status of the NTP service.
Run the display ntp-service sessions [ verbose ] command to view the status of NTP
sessions.
Run the display ntp-service trace command to view the summary information on each
passing NTP server when tracing from the local device to the reference clock source.
Run the display ntp-service statistics packet [ ipv6 | [ peer [ ip-address [ vpn-instance
vpn-instance-name ] | ipv6 [ ipv6-address [ vpn-instance vpn-instance-name ] ] ] ] ]
command to view the statistics of global NTP packets.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 NTP Configuration
224