Huawei S9300 Configuration Manual page 76

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Enable global LLDP on SwitchA and SwitchB.
# Configure SwitchA.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] lldp enable
# Configure SwitchB.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] lldp enable
Step 2 Configure management addresses for SwitchA and SwitchB.
# Configure SwitchA.
[SwitchA] lldp management-address 10.10.10.1
# Configure SwitchB.
[SwitchB] lldp management-address 10.10.10.2
Step 3 Enable the LLDP trap function on SwitchA and SwitchB.
# Configure SwitchA.
[SwitchA] snmp-agent trap enable feature-name lldptrap
# Configure SwitchB.
[SwitchB] snmp-agent trap enable feature-name lldptrap
Step 4 Verify the configuration.
# Check whether the LLDP function is enabled, management addresses are configured, and the
LLDP trap function is enabled.
l View the configurations on SwitchA.
Issue 01 (2012-03-15)
Enable global LLDP on SwitchA and SwitchB.
Configure management addresses for SwitchA and SwitchB.
Enable the LLDP trap function on SwitchA and SwitchB.
Management address 10.10.10.1 for SwitchA and management address 10.10.10.2 for
SwitchB
[SwitchA] display lldp local
System information
--------------------------------------------------------------------------
Chassis
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 LLDP Configuration
61