Enabling The Rmon Statistics Function On The Interface; Configuring The Ethernetstatstable - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

8.3.2 Enabling the RMON Statistics Function on the Interface

You need to enable traffic statistics function on the interface where traffic statistics are collected.
If the traffic statistics function is not enabled on the interface, statistics values of in both
ethernetStatsTable and HistoryControlTable are 0.
Context
Do as follows on the switch on which traffic statistics should be collected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { ethernet | gigabitethernet | xgigabitethernet } interface-number
The interface view is displayed.
Step 3 Run:
rmon-statistics enable
The RMON statistics function is enabled on the interface.
If the statistics function is not enabled on the interface, the statistics value in ethernetStatsTable
and historyControlTable of RMON is 0.
----End

8.3.3 Configuring the ethernetStatsTable

EthernetStatsTable records traffic information that RMON collects on interfaces.
Context
Do as follows on the switch on which traffic statistics should be collected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { ethernet | gigabitethernet | xgigabitethernet } interface-number
The interface view is displayed.
Step 3 Run:
rmon statistics entry-number [ owner owner-name ]
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 RMON and RMON2 Configuration
537