Configuring Uni-Directional Transmission Delay Thresholds; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
nqa test-instance admin jitter
test-type jitter
destination-address ipv4 100.1.1.201
destination-port 80
threshold rtd 2000
send-trap rtd
nqa status : normal
6.30 Configuring Uni-directional Transmission Delay
Thresholds
This section describes how to set a one-way transmission delay threshold in an NQA test
instance. After a one-way transmission delay threshold is set in an NQA test instance, the test
result will contain the statistics on the test packets that exceed the set threshold. This provides
the basis for the network manager to analyze the operating status of the specified service on the
network.

6.30.1 Establishing the Configuration Task

Before setting a one-way transmission delay threshold, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
In all jitter type tests ( except PathJiiter and LSPJiiter ), after the uni-directional transmission
delay threshold is configured, the test results contain statistics on the test packets that exceed
the set threshold. This provides the basis for the network manager to analyze the operation status
of the specified service.
Pre-configuration Tasks
Before configuring the uni-directional transmission delay threshold, complete the following
tasks:
l
l
Data Preparation
To configure the uni-directional transmission delay threshold, you need the following data.
No.
1
2
Issue 01 (2012-03-15)
Running the device normally
Creating NQA tests and configuring related parameters correctly
Data
Administrator name and test name
Uni-directional transmission delay threshold
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
365