Huawei S9300 Configuration Manual page 327

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
destination-address ipv4 ip-address { lsp-masklen masklen | lsp-loopback loopback-
address }*
The destination IP address to be tested is configured.
Step 6 (Optional) Perform the following as required to configure other parameters for the LSP Trace
test:
l To configure a protocol used by the LSP ping test, run the lsp-version { rfc4379 | draft6 }
l To configure the next-hop IP address in the scenario where load balancing is enabled on the
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure after how many hops the test is considered failed, run the tracert-
l To configure the initial and the maximum TTL values of the packet, run the tracert-
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End
Issue 01 (2012-03-15)
command.
initiator of the LSP ping test, run the lsp-nexthop nexthop-ip-address command.
NOTE
The next-hop IP address can be configured only when lsp-type is IPv4 and lsp-version is RFC 4379.
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
NOTE
In a uni-directional LSP Trace test, if the lsp-replymode no-reply command is configured, the test
result displays that the test fails regardless of whether the test is successful or fails. If the test is
successful, the test result also displays the number of the timeout packets. If the test fails, the test result
displays the number of the discarded packets.
hopfailtimes timescommand.
livetime first-ttl first-ttl max-ttl max-ttl command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
312