Huawei S9300 Configuration Manual page 273

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.9 Configuring the DNS Test
This section describes how to configure a Domain Name System (DNS) test to check the DNS
resolution speed.
6.10 Configuring the Traceroute Test
This section describes how to configure a traceroute test to check the connectivity to each hop
on the network.
6.11 Configuring the SNMP Query Test
This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.
6.12 Configuring the TCP Test
This section describes how to configure a Transmission Control Protocol (TCP) test to check
the responding speed of a TCP port.
6.13 Configuring the UDP Test
This section describes how to configure a User Datagram Protocol (UDP) test to check the
responding speed of a UDP port.
6.14 Configuring the Jitter Test
This section describes how to configure a jitter test to check jitter on the network. You can
perform a jitter test only when both the client and the server are Huawei devices.
6.15 Configuring the MAC Ping Test
This section describes how to perform the MAC ping test with NQA.
6.16 Configuring the LSP Ping Test
This section describes how to configure a Label Switched Path (LSP) ping test to check the
operating status of the LSP.
6.17 Configuring the LSP Jitter Test
This section describes how to configure an LSP jitter test to measure jitter in the LSP during the
packet transmission.
6.18 Configuring the LSP Trace Test
This section describes how to configure an LSP trace test to check the connectivity between
Label Switching Routers (LSRs) along the LSP.
6.19 Configuring an ICMP Jitter Test
This section describes how to configure an ICMP jitter test to measure jitter on IP networks.
6.20 Configuring the NQA MTrace Test to Check the RPF Path from the Multicast Source to
the Querier
This section describes how to configure a Multicast Traceroute (MTrace) test to check the
Reserved Path Forwarding (RPF) path from the multicast source to the querier.
6.21 Configuring the NQA MTrace Test to Check the Multicast Path from the Multicast Source
to the Querier
This section describes how to configure an MTrace test to check the multicast path from the
multicast source to the querier.
6.22 Configuring the NQA MTrace Test to Check the RPF Path from the Multicast Source to
the Destination Host
This section describes how to configure an MTrace test to check the RPF path from the multicast
source to the destination host.
6.23 Configuring the NQA MTrace Test to Check the Multicast Path from the Multicast Source
to the Destination Host
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
258