Configuring The Lsp Ping Test; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.16 Configuring the LSP Ping Test

This section describes how to configure a Label Switched Path (LSP) ping test to check the
operating status of the LSP.

6.16.1 Establishing the Configuration Task

Before configuring an LSP ping test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
The NQA LSP Ping test can be used to test the reachability of the following types of Label
Switched Paths (LSPs) and collect statistics about Link State Advertisement (LSA).
l
l
l
After the test parameters are configured and the test is started,
1.
2.
3.
Pre-configuration Tasks
Before configuring the LSP Ping test, you need the following configuration:
l
l
l
Data Preparation
To configure the LSP Ping test, you need the following data.
Issue 01 (2012-03-15)
Max Delay SD:0
Delay SD Square Sum:0
Packet Loss SD:0
Packet Loss Unknown:0
Average of Jitter SD:0
jitter out value:0.0000000
NumberOfOWD:0
OWD SD Sum:0
ICPIF value: 0
TimeStamp unit: ms
Packet Rewrite Ratio: 0%
Packet Disorder Ratio: 0%
Fragment-disorder Ratio: 0%
LSP tunnels
MPLS TE tunnels
MPLS CR-LSP hotstandby tunnels
NQA creates an MPLS Echo-Request packet and adds the address 127.0.0.0/8 to the IP
packet header as the destination IP address. The packet is forwarded along the specified
LSP in the MPLS network.
The egress monitors port 3503 that sends Echo packets.
The ingress collects the test results based on the received Echo packets.
LSP tunnel
or an MPLS TE tunnel.
or an MPLS CR-LSP hotstandby tunnel
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Max Delay DS:0
Delay DS Square Sum:0
Packet Loss DS:0
Average of Jitter:0
Average of Jitter DS:0
jitter in value:0.0000000
Packet Loss Ratio: 100%
OWD DS Sum:0
MOS-CQ value: 0
Packet Rewrite Number: 0
Packet Disorder Number: 0
Fragment-disorder Number: 0
6 NQA Configuration
298