Configuring The Jitter Test; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Context
Procedure
l
l
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
<Quidway> display nqa results
NQA entry(admin, udp) :testflag is inactive ,testtype is udp
1 . Test 1 result
Run the display nqa-server command. If the status of the NQA server is displayed, it means
that the configuration succeeds.
<Quidway> display nqa-server
NQA Server Max: 5000
NQA Concurrent TCP Server : 0
nqa-server udpecho 10.112.58.3 3000 ACTIVE

6.14 Configuring the Jitter Test

This section describes how to configure a jitter test to check jitter on the network. You can
perform a jitter test only when both the client and the server are Huawei devices.

6.14.1 Establishing the Configuration Task

Before configuring a jitter test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
The jitter time refers to the interval for sending two adjacent packets minus the interval for
receiving the two packets.
Issue 01 (2012-03-15)
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Run the display nqa results [ test-instance admin-name test-name ] command to view the
test results on the NQA client.
Run the display nqa-server command to view the information about the NQA server.
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 32/109/67
Sum/Square-Sum Completion Time: 203/16749
Last Good Probe Time: 2006-8-5 16:9:21.6
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
NQA Server Num: 1
NQA Concurrent UDP Server: 1
6 NQA Configuration
290