Huawei S9300 Configuration Manual page 417

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Figure 6-12 Networking diagram for configuring the Jitter test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure the NQA server on Switch C.
# Configure the IP address and UDP port number monitored by the NQA server.
<SwitchC> system-view
[SwitchC] nqa-server udpecho 10.2.1.2 9000
Step 3 # Configure Switch A.
# Enable the NQA client and create an NQA Jitter test.
<SwitchA> system-view
[SwitchA] nqa test-instance admin jitter
[SwitchA-nqa-admin-jitter] test-type jitter
[SwitchA-nqa-admin-jitter] destination-address ipv4 10.2.1.2
[SwitchA-nqa-admin-jitter] destination-port 9000
Step 4 Perform the test.
[SwitchA-nqa-admin-jitter] start now
Step 5 Verify the test result.
Issue 01 (2012-03-15)
NOTE
For information about clock synchronization, see "NTP" in the S9300&S9300E Terabit Routing Switch
Feature Description - Network Management.
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch C as the NTP client and configure Switch B as the NTP server.
Configure Switch A as the NQA client and configure Switch C as the NQA server.
Configure the service type and port number monitored by the NQA server.
Create and perform the NQA Jitter test on the NQA client.
Host address of the server
Port number used to monitor the UDP service on the server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE2/0/0
VLANIF110
VLANIF110
10.2.1.1/24
10.2.1.2/24
6 NQA Configuration
SwitchC
GE1/0/0
NQA Server
402