Huawei S9300 Configuration Manual page 31

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 (Optional) Run:
snmp-agent
The SNMP agent function is enabled.
By default, the SNMP agent function is disabled. Running any command with the parameter
snmp-agent can enable the SNMP agent function, so this step is optional.
Step 3 Run:
snmp-agent sys-info version v2c
The SNMP version is set.
By default, SNMPv3 is enabled.
After SNMPv2c is enabled on the managed device, the device supports both SNMPv2c and
SNMPv3. This means that the device can be monitored and managed by NM stations running
SNMPv2c and SNMPv3.
Step 4 Run:
snmp-agent community { read | write } community-name
The community name is set.
l read must be configured in the command if the NM station administrator requires the read
l write must be configured in the command if the NM station administrator requires the read
After the community name is set, if no MIB view is configured, the NM station that uses the
community name has rights to access objects in the Viewdefault view.
Step 5 Choose one of the following commands as needed to configure the destination IP address for
the alarms and error codes sent from the device.
l If the network is an IPv4 network, configure the device to send either traps or informs to the
Issue 01 (2012-03-15)
permission in a specified view in some cases. For example, a low-level administrator must
read certain data.
and write permissions in a specified view in some cases. For example, a high-level
administrator must read and write certain data.
NM station.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
16