Huawei S9300 Configuration Manual page 253

Table of Contents

Advertisement

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure IP addresses for Switch C, Switch D, and Switch E.
Configure an IP address for each interface according to
three Switches can ping each other.
The configuration procedure is not mentioned.
Step 2 Configure the unicast NTP client/server mode.
# On Switch C, set the clock as a master NTP clock with stratum being 2.
<SwitchC> system-view
[SwitchC] ntp-service refclock-master 2
# Configure Switch C as the NTP server of Switch D.
<SwitchD> system-view
[SwitchD] ntp-service unicast-server 3.0.1.31
After the configurations, the clock of Switch D is synchronized with the clock of Switch C.
Check the NTP status of Switch D, and you can see that the status of the clock is synchronized.
This means that the synchronization is complete. The stratum of the clock of Switch D is 3, one
stratum lower than the clock stratum of Switch C.
[SwitchD] display ntp-service status
clock status: synchronized
clock stratum: 3
reference clock ID: 3.0.1.31
nominal frequency: 64.0029 Hz
actual frequency: 64.0029 Hz
clock precision: 2^7
clock offset: 0.0000 ms
root delay: 62.50 ms
root dispersion: 0.20 ms
peer dispersion: 7.81 ms
reference time: 06:52:33.465 UTC Mar 7 2006(C7B7AC31.773E89A8)
Step 3 Configure the unicast NTP peer mode.
# Configure Switch D as the passive peer of Switch E.
<SwitchE> system-view
[SwitchE] ntp-service unicast-peer 3.0.1.32
No master clock is configured on Switch E, so the clock on Switch E should be synchronized
to the clock on Switch D.
Issue 01 (2012-03-15)
Configure Switch E and Switch D as the NTP peers so that Switch E should send clock
synchronization requests to Switch D.
The clocks on Switch C, Switch D and Switch E can be synchronized.
IP address of Switch C
IP address of Switch D
Stratum count of the NTP master clock
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 NTP Configuration
Figure
4-3. After configurations, the
238

Advertisement

Table of Contents
loading

This manual is also suitable for:

S9300e

Table of Contents