Example For Configuring The Lsp Jitter Test For A Common Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.35.13 Example for Configuring the LSP Jitter Test for a Common
Tunnel
Networking Requirements
As shown in
l
l
l
The NQA LSP Ping test is used to check the connectivity of the LSP between Switch A and
Switch C.
Figure 6-15 Networking diagram for configuring the LSP Jitter test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
Issue 01 (2012-03-15)
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 10.2.1.0 0.0.0.255
#
return
Figure 6-15:
The OSPF protocol runs on Switch A, Switch B, and Switch C. The three Switches learn
the 32-bit host routes on their loopback interfaces.
MPLS and MPLS LDP are enabled on Switch A, Switch B, and Switch C.
MPLS and MPLS LDP are enabled on VLANIF interfaces connected to Switch A,
Switch B, and Switch C to trigger the establishment of an LDP LSP.
Loopback1
1.1.1.9/32
GE1/0/0
VLANIF100
VLANIF100
10.1.1.1/24
10.1.1.2/24
Configure Switch A as the NQA client.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
area 0
Loopback1
2.2.2.9/32
GE1/0/0 GE2/0/0
VLANIF110
10.2.1.1/24
SwitchB
6 NQA Configuration
Loopback1
3.3.3.9/32
GE1/0/0
VLANIF110
10.2.1.2/24
SwitchC
410