Example For Configuring The Traceroute Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.35.6 Example for Configuring the Traceroute Test

Networking Requirements
As shown in
The traceroute test is used to check the IP address of the VLANIF 110 interface of Switch C on
Switch A.
Figure 6-8 Networking diagram for configuring the traceroute test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Create an NQA traceroute test on Switch A and set the destination IP address to 10.2.1.2.
<SwitchA> system-view
[SwitchA] nqa test-instance admin trace
[SwitchA-nqa-admin-trace] test-type trace
[SwitchA-nqa-admin-trace] destination-address ipv4 10.2.1.2
Step 3 Perform the test.
[SwitchA-nqa-admin-trace] start now
Step 4 Verify the test result.
# Verify the NQA test result on Switch A.
[SwitchA-nqa-admin-trace] display nqa results test-instance admin trace
NQA entry(admin, trace) :testflag is inactive ,testtype is trace
1 . Test 1 result
Issue 01 (2012-03-15)
Figure 6-8:
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client.
Create and perform the traceroute test on Switch A to check the statistics on each hop from
Switch A to Switch C.
Destination address for the traceroute test
The test is finished
Completion:success
Disconnect operation number:0
System busy operation number:0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE2/0/0
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
Attempts number:1
Operation timeout number:0
Connection fail number:0
6 NQA Configuration
SwitchC
GE1/0/0
393