Huawei S9300 Configuration Manual page 426

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
2.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure LDP on Switch A, Switch B, and Switch C. (The detailed procedure is not mentioned
here.)
For the configuration of LDP, refer to the S9300&S9300E Terabit Routing Switch Configuration
Guide - MPLS.
Step 3 Configure Switch A as the NQA client.
# Enable the NQA client and configure the LDP LSP Ping test.
<SwitchA> system-view
[SwitchA] nqa test-instance admin lspjitter
[SwitchA-nqa-admin-lspjitter] test-type lspjitter
[SwitchA-nqa-admin-lspjitter] lsp-type ipv4
[SwitchA-nqa-admin-lspjitter] destination-address ipv4 3.3.3.9 lsp-masklen 32 lsp-
loopback 127.0.0.1
Step 4 Perform the test.
[SwitchA-nqa-admin-lspjitter] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-lspjitter] display nqa results test-instance admin lspjitter
NQA entry (admin, lspjitter) :testflag is inactive ,testtype is lspjitter
1 . Test 1 result
----End
Configuration Files
l
Issue 01 (2012-03-15)
Configure Switch C as the NQA server.
Create an LSP Jitter test on Switch A.
Host address and mask of the NQA server
The test is finished
SendProbe:60
Completion :success
Min/Max/Avg/Sum RTT:1/1/1/60
NumOfRTT:60
Operation sequence errors number:0
System busy operation number:0
Min Positive SD:0
Positive SD Number:0
Positive SD Square Sum :0
Max Negative SD:1
Negative SD Sum:1
Packet Loss Unknown:0
jitter out value:0.0162967
Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 100
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:60
RTD OverThresholds number:0
RTT Square Sum:60
Drop operation number:0
RTT Stats errors number:0
Operation timeout number:0
Max Positive SD:0
Positive SD Sum:0
Min Negative SD:0
Negative SD Number:1
Negative SD Square Sum :1
Average of Jitter SD:1
6 NQA Configuration
411