Huawei S9300 Configuration Manual page 496

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

Figure 6-32 Networking diagram of configuring MAC ping for detecting the connectivity of a

VPLS network

Configuration Roadmap

The configuration roadmap is as follows:

Data Preparation

To complete the configuration, you need the following data:

Issue 01 (2012-03-15)

100.2.1.2/30

100.2.1.1/30

100.1.1.1/30

Configure a Martini VPLS network and the service environment for starting the NQA test

Configure VPLS-based Ethernet CFM on PEs.

Configure an NQA MAC ping test instance on PE1 to detect the connectivity of the VPLS

IP address of an interface

MPLS LSR ID of each PE

VSI names and VSI IDs on PE1, PE2, and PE3

Interface to which the VSI is bound

Name and level of the MD, name of the MA, MEP ID, name of the interface where the

MEP resides, and type of the MEP

Destination MAC address

Huawei Proprietary and Confidential

100.3.1.2/30

100.1.1.2/30

6 NQA Configuration

100.3.1.1/30