Huawei S9300 Configuration Manual page 155

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure a management VLAN.
# Create VLAN 10 on the device and add interfaces of the administrator switch and member
switches to VLAN 10.
# Configure the administrator switch.
<Quidway> system-view
[Quidway] sysname Administrator-1
[Administrator-1] vlan 10
[Administrator-1-vlan10] quit
[Administrator-1] interface gigabitethernet 1/0/1
[Administrator-1-GigabitEthernet1/0/1] port link-type trunk
[Administrator-1-GigabitEthernet1/0/1] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet1/0/1] quit
[Administrator-1] interface gigabitethernet 1/0/2
[Administrator-1-GigabitEthernet1/0/2] port link-type trunk
[Administrator-1-GigabitEthernet1/0/2] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet1/0/2] quit
[Administrator-1] interface gigabitethernet 1/0/3
[Administrator-1-GigabitEthernet1/0/3] port link-type trunk
[Administrator-1-GigabitEthernet1/0/3] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet1/0/3] quit
[Administrator-1] interface vlanif 10
[Administrator-1-Vlanif10] quit
# Configure member switch 1.
<Quidway> system-view
[Quidway] sysname Member-1
[Member-1] vlan 10
[Member-1-vlan10] quit
[Member-1] interface gigabitethernet 1/0/1
[Member-1-GigabitEthernet1/0/1] port link-type trunk
[Member-1-GigabitEthernet1/0/1] port trunk allow-pass vlan 10
[Member-1-GigabitEthernet1/0/1] quit
[Member-1] interface gigabitethernet 1/0/2
[Member-1-GigabitEthernet1/0/2] port link-type trunk
[Member-1-GigabitEthernet1/0/2] port trunk allow-pass vlan 10
[Member-1-GigabitEthernet1/0/2] quit
[Member-1] interface vlanif 10
[Member-1-Vlanif10] quit
Issue 01 (2012-03-15)
Enable SNMP NAT on the administrator switch (The function is enabled by default.)
NOTE
Related configurations of cluster NAT must be performed on the administrator switch.
Assign an IP address to the SNMP host.
Management VLAN ID of the cluster, that is 10
IP address of the SNMP host, that is 3.0.0.1/8
IP address of VLANIF 10 that is 1.0.0.1/8 and a reachable route between VLANIF 10 and
the SNMP host
Address pool of the cluster, that is 10.0.0.0/8
IP address of the administrator switch used in the cluster, that is 10.0.0.1/8
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
140