Example For Configuring The Lsp Ping Test For A Common Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.35.12 Example for Configuring the LSP Ping Test for a Common
Tunnel
Networking Requirements
As shown in
l
l
l
The NQA LSP Ping test needs to be performed to check the connectivity of the LSP between
Switch A and Switch C.
Figure 6-14 Networking diagram for configuring the LSP Ping test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
Issue 01 (2012-03-15)
Figure 6-14:
The OSPF protocol runs on Switch A, Switch B, and Switch C. The three Switches learn
the 32-bit host routes on their loopback interfaces.
MPLS and MPLS LDP are enabled on Switch A, Switch B, and Switch C.
MPLS and MPLS LDP are enabled on VLANIF interfaces connected to Switch A,
Switch B, and Switch C to trigger the establishment of an LDP LSP.
Loopback1
1.1.1.9/32
GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client.
Configure Switch C as the NQA server.
Create an LSP Ping test on Switch A.
Host address and mask of the NQA server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
area 0
Loopback1
2.2.2.9/32
GE2/0/0
GE1/0/0
VLANIF110
10.2.1.1/24
SwitchB
6 NQA Configuration
Loopback1
3.3.3.9/32
GE1/0/0
VLANIF110
10.2.1.2/24
SwitchC
407