Huawei S9300 Configuration Manual page 289

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The test type is set to HTTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters for the HTTP test
( For detailed parameter configurations, see the chapter
Parameters
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the source port, run the source-port port-number command.
l To configure the destination port, run the destination-port port-number command.
l To configure the percentage of the failed NQA HTTP tests, run the fail-percent percent
l To configure the NQA test packet to be sent without searching the routing table, run the
Step 6 Run:
http-operation { get | post }
The HTTP operation type is configured.
By default, the HTTP operation type is Get.
Step 7 Run:
http-url deststring [ verstring ]
The web page to be visited and the HTTP version are configured.
Step 8 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
Issue 01 (2012-03-15)
):
command.
command.
sendpacket passroute command.
NOTE
When information on the HTTP version is not configured, by default, HTTP1.0 is supported. HTTP1.1 can
be supported through your configurations.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Configuring Universal NQA Test
274