Setting Parameters For The Mac Ping Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.15.2 Setting Parameters for the MAC Ping Test

Context
Perform the following steps on the NQA client.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm enable
The CFM is enabled globally.
Step 3 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 4 Run:
test-type macping
The test type is set to MAC Ping.
Step 5 Run:
destination-address mac mac-address
The destination MAC address is specified for the MAC ping test.
Or, run:
destination-address remote-mep mep-id rmep-id
The REMP ID is specified for the MAC ping test. Configure the destination address or REMP
ID as required.
Step 6 Run:
md md-name ma ma-name
The MD and the MA are specified.
Step 7 (Optional) Run the following commands to set other parameters for the MAC Ping test.
l Run:
l Run:
The interval should be longer than the timeout period.
Step 8 Run:
start
Issue 01 (2012-03-15)
interval seconds interval
The interval for sending test packets is set.
fail-percent percent
The percentage of failed NQA tests is set.
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
296