Huawei S9300 Configuration Manual page 376

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
Issue 01 (2012-03-15)
NOTE
This parameter cannot be configured for Path Jitter and MTrace test instances.
source-address ipv4 ip-address
The source IP address is set for the NQA test instance.
NOTE
This parameter cannot be configured for DNS, PWE3 Ping, and PWE3 Trace test instances.
source-interface interface-type interface-number
The source interface is configured for the NQA test instance.
NOTE
The source interface can be configured for ICMPtest instances.
source-port port-number
The source port number is set for the NQA test instance.
NOTE
This parameter can be configured for UDP, SNMP, TCP, ICMP Jitter, LSP Jitter, FTP, and HTTP test
instances.
test-failtimes times
The trap threshold for continuous probe failures is set for the NQA test instance.
NOTE
This parameter cannot be configured for MTrace test instances.
timeout time
The timeout period is set for the NQA test instance.
ttl number
The TTL value in the NQA test packet is set.
NOTE
This parameter cannot be configured for DNS, and PWE3 Ping test instances.
tos value
Type of Service (TOS) is set for the test packet.
NOTE
This parameter cannot be configured for DNS, LSP Ping, LSP Trace, LSP Jitter, PWE3 Ping, PWE3
Trace, and MTrace test instances.
tracert-hopfailtimes times
The hop fail times are set for the Trace test instance.
NOTE
This parameter can be configured only for Trace, LSP Trace and PWE3 Trace test instances.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
361