Configuring Parameters For The Icmp Jitter Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
No.
4

6.19.2 Configuring Parameters for the ICMP Jitter Test

This part describes how to set ICMP jitter test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type icmpjitter
The type of the test instance is configured as ICMP jitter.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Run the following commands to configure other parameters for the jitter test:
l Run:
l Run:
l Run:
l Run:
Issue 01 (2012-03-15)
Data
Start mode and end mode
icmp-jitter-mode { icmp-echo | icmp-timestamp }
The mode of the ICMP jitter test is configured.
vpn-instance vpn-instance-name
The VPN instance to be tested is configured.
probe-count number
The number of test probes to be sent each time is set.
jitter-packetnum number
The number of test packets to be sent during each test is set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
318