Example For Configuring Test Results To Be Sent To The Ftp Server - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.35.26 Example for Configuring Test Results to Be Sent to the FTP
Server
This part provides examples for sending send test results to the FTP server to save test results
to the most extent.
Networking Requirements
As shown in
results to the FTP server through FTP.
Figure 6-28 Networking diagram of sending test results to the FTP server
VLANIF20
11.1.2.1/24
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
7.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure parameters for connecting the FTP server.
# Configure the IP address of the client that is connected to the FTP server.
Issue 01 (2012-03-15)
Figure 6-28, Switch A serves as the client to perform the ICMP test and send test
FTP server
11.1.2.8/24
GE2/0/0
GE1/0/0
VLANIF10
11.1.1.11/24
Configure parameters for connecting the FTP server.
Enable the FTP server to save test results through FTP.
Configure the number of test results saved through FTP.
Configure the duration of saving test results through FTP.
Configure test results to be sent.
Start the test instance.
Verify the configuration.
User name and password used for logging into the FTP server
Number of test results saved through FTP
Duration of saving test results through FTP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
SwitchB
VLANIF10
11.1.1.10/24
6 NQA Configuration
469