Performing Ping And Tracert Operations; Establishing The Configuration Task; Checking Network Connectivity Through The Ping Operation - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

5.3 Performing Ping and Tracert Operations

This section describes the execution of the ping and tracert commands.

5.3.1 Establishing the Configuration Task

Application Environment
The Customer Edge (CE) connected to the S9300&S9300E cannot access the Internet. You need
to run the ping and tracert commands to check network connectivity.
Pre-configuration Tasks
Before performing ping and tracert operations, complete the following tasks:
l
l
Data Preparation
To perform ping and tracert operations, you need the following data.
No.
1
2

5.3.2 Checking Network Connectivity Through the Ping Operation

Context
Do as follows on the S9300&S9300E:
Procedure
Step 1 Run:
ping [ ip ] [ -a source-ip-address | -c count | -d | -f | -h ttl-value | -i
interface-type interface-number | -m time | -n | -p pattern | -q | -r | -s
packetsize | -t timeout | -tos tos-value | -v ]
Network connectivity is tested.
Only some of the parameters are specified in the preceding ping command. For details on more
parameters, refer to the S9300&S9300E Terabit Routing Switch Command Reference.
The output of the ping command is as follows:
Issue 01 (2012-03-15)
Checking the physical connections between the CE and the S9300&S9300E
Correctly configuring an IP address for the CE device
Data
IP address of the CE device
IP address of the gateway
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Ping and Tracert
*
host
252