Configuring The Aggregation Function; Checking The Configuration; Configuring The Flexible Netstream Feature; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

7.5.5 Configuring the Aggregation Function

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-
tos | prefix | prefix-tos | protocol-port | protocol-port-tos | source-prefix |
source-prefix-tos }
The NetStream aggregation view is displayed.
Step 3 Run:
enable
The aggregation mode is enabled.
----End

7.5.6 Checking the Configuration

Prerequisites
All configurations are complete.
Procedure
Step 1 Run the display netstream all command to view the NetStream configuration.
----End

7.6 Configuring the Flexible NetStream Feature

This section describes how to configure the Flexible NetStream feature to flexibly create
NetStream statistics according to records.

7.6.1 Establishing the Configuration Task

Applicable Environment
To collect statistics on packets based on the protocol type, DSCP field, source IP address,
destination IP address, source port number, destination port number, or traffic label on the IP
network, you can configure Flexible NetStream.
Pre-configuration Tasks
Before configuring Flexible NetStream, complete the following task:
l
Issue 01 (2012-03-15)
Setting physical parameters on interfaces
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
514