Optional) Configuring The Format Of Exported Packets; Setting The Destination Address Of Statistics - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
By default, the fixed-packets sampling ratio on an interface is 1000:1.
----End

7.4.3 (Optional) Configuring the Format of Exported Packets

IPv6 original traffic can be exported only in the v9 format. Therefore, the output format must
be configured to v9 for IPv6 traffic.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ipv6 netstream export version 9 [ origin-as | peer-as ]
The format of the exported packets is configured.
By default, the version number is 5 and no AS option is used.
----End

7.4.4 Setting the Destination Address of Statistics

Context
You cannot export the IPv6 NetStream statistics without a pre-configured destination address.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 (Optional) Run:
ipv6 netstream export source ip-address
The source address for exporting statistics is configured.
By default, the source address of the exported packets carrying the NetStream statistics is the
address of the VLANIF interface through which packets are exported.
Step 3 Run:
ipv6 netstream export host ip-address port-number
The destination IP address of the exported statistics, that is, the IP address of the NSC, is
configured.
You can configure up to 2 destination addresses to implement the backup between 2 NSCs.
----End
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
509