Huawei S9300 Configuration Manual page 429

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

Figure 6-16 Networking diagram of a LSP jitter test

Configuration Roadmap

The configuration roadmap is as follows:

Data Preparation

To complete the configuration, you need the number of the MPLS TE tunnel interface.

Step 1 Configure routes between Switch A, Switch B, and Switch C. (The detailed procedure is not

mentioned here.)

Step 2 Configure MPLS RSVP-TE on Switch A, Switch B, and Switch C. (The detailed procedure is

not mentioned here.)

For the configuration of MPLS RSVP-TE, refer to the S9300&S9300E Terabit Routing Switch

Configuration Guide - MPLS.

Step 3 Set up a TE tunnel from Switch A to Switch C. (The detailed procedure is not mentioned here.)

Step 4 Create an NQA test on Switch A.

# Enable the NQA client and create an LSP Jitter test for the TE tunnel.

<SwitchA> system-view

[SwitchA] nqa test-instance admin lspjitter

[SwitchA-nqa-admin-lspjitter] test-type lsptrace

[SwitchA-nqa-admin-lspjitter] lsp-type te

[SwitchA-nqa-admin-lspjitter] lsp-tetunnel tunnel 1/0/0

Step 5 Start the test.

Issue 01 (2012-03-15)

Configure Switch A as an NQA client.

Create an LSP Jitter test on Switch A.

Huawei Proprietary and Confidential

6 NQA Configuration