Example For Configuring A Threshold For The Nqa Alarm - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l

6.35.27 Example for Configuring a Threshold for the NQA Alarm

This part provides examples for configuring the actions that the system needs to perform in
response to the threshold exceeding, such as generating logs, generating traps, or generating logs
and traps.
Networking Requirements
As shown in
monitor the packet loss ratio of the test result. If the ratio exceeds the threshold, an alarm is sent
to the NM station.
Figure 6-29 Networking diagram of configuring a threshold for the NQA alarm
VLANIF20
11.1.2.1/24
SwitchA
Issue 01 (2012-03-15)
port hybrid pvid vlan 20
port hybrid untagged vlan 20
#
nqa-ftp-record enable
nqa-ftp-record trap-enable
nqa-ftp-record ip-address 11.1.2.8
nqa-ftp-record username ftp
nqa-ftp-record password ftp
nqa-ftp-record filename icmp
nqa-ftp-record item-num 10010
nqa-ftp-record time 2
nqa test-instance admin icmp
test-type icmp
destination-address ipv4 11.1.1.10
#
return
Configuration file of Switch B
#
sysname SwitchB
vlan batch 10
#
interface Vlanif10
ip address 11.1.1.10 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
return
Figure 6-29, Switch A serves as the client to perform the ICMP jitter test and
NM Station
11.1.2.8/24
GE2/0/0
GE1/0/0
VLANIF10
11.1.1.1/24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
SwitchB
VLANIF10
11.1.1.20/24
6 NQA Configuration
471