Huawei S9300 Configuration Manual page 562

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Figure 8-1 Networking diagram for configuring RMON
1.1.1.1/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
7.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Set IP addresses for the interfaces of the Switch. The configuration procedure is not mentioned
here.
Step 2 Configure a reachable route between the Switch and the NMS. The configuration procedure is
not mentioned.
Step 3 Configure the Switch to send trap messages to the NMS.
# Enable the function of sending trap messages through SNMP.
<Quidway> system-view
[Quidway] sysname Switch
[Switch] snmp-agent trap enable
# Configure the function of sending trap messages to the specified NMS.
[Switch] snmp-agent target-host trap address udp-domain 1.1.1.1 params securityname
public
Step 4 Enable the statistics function.
Issue 01 (2012-03-15)
IP
Network
NMS
Assign IP addresses to interfaces of the Switch.
Configure a reachable route between the Switch and the NMS.
Configure the function of sending trap messages and set the group names by using SNMP
commands.
Enable the statistics function and configure the statistics table.
Configure the historyControlTable.
Configure the eventTable.
Configure the alarmTable and prialarmTable.
Interval for sampling data
Threshold for triggering alarms
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 RMON and RMON2 Configuration
GE1/0/0
VLANIF100 VLANIF110
2.2.2.1/24 3.3.3.1/24
Switch
GE3/0/0
547