Huawei S9300 Configuration Manual page 248

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
Figure 4-2 Networking diagram for configuring the unicast client/server mode
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure the IP addresses of the Switches and ensure that the routes between them are reachable.
Configure the IP addresses according to
Switch D are routable.
Issue 01 (2012-03-15)
NTP authentication needs to be enabled.
IP
VLANIF100
Network
2.2.2.2/24
SwitchA
Configure Switch A as an NTP server and configure the master clock on Switch A.
Configure Switch B as an NTP client. Switch B synchronizes its clock with the clock of
Switch A.
Configure Switch C and Switch D to synchronize their clocks with the clock of Switch B.
Configure NTP authentication on Switch A, Switch B, Switch C, and Switch D.
NOTE
When configuring NTP authentication in unicast client/server mode, pay attention to the following
points:
l You must enable NTP authentication on the client before specifying the IP address of the NTP
server and authentication key to be sent to the server; otherwise, NTP authentication is not
performed before clock synchronization.
l To implement authentication successfully, configure both the server and the client.
IP address of the reference clock
Stratum count of the NTP master clock
Key ID
Password
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF111
VLANIF110
10.0.0.1/24
1.0.1.11/24
SwitchB
Figure 4-2 so that Switch A, Switch B, Switch C and
4 NTP Configuration
VLANIF111
10.0.0.2/24
SwitchC
VLANIF111
10.0.0.3/24
SwitchD
233