Configuring The Netstream Function On An Interface - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
Data Preparation
To configure NetStream, you need the following data.
No.
1
2
3

7.4.2 Configuring the NetStream Function on an Interface

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ipv6 netstream { inbound | outbound }
The NetStream function is enabled on the interface to collect statistics about IPv6 unicast traffic.
By default, the NetStream function is disabled in inbound and outbound directions. In this case,
statistics about IPv6 unicast traffic are not collected.
The Netstream can collect statistics about inbound and outbound packets separately.
Step 4 (Optional) Run:
ip netstream suppress suppress-rate { inbound | outbound }
The suppression ratio of the packets on the interface is set.
By default, the suppression ratio on interfaces is 1000.
The suppression ratio is used for packet sampling. After the suppression ratio is set, the
S9300&S9300E does not sample the packets that are filtered out in the suppression.
Step 5 (Optional) Run:
ipv6 netstream sampler fix-packets packet-interval { inbound | outbound }
The fixed-packets sampling ratio is set on the interface.
Issue 01 (2012-03-15)
Setting the link-layer parameters of the interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version of the exported packets of the
NetStream traffic statistics
IP addresses and port numbers of the NSC
508