Configuring The Netstream Function On An Interface; Optional) Configuring The Version Of Exported Packets - Huawei S9300 Configuration Manual

Table of Contents

Advertisement

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
No.
3

7.5.2 Configuring the NetStream Function on an Interface

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ip netstream { inbound | outbound }
The NetStream function is enabled on the interface to collect statistics about IPv4 unicast traffic.
By default, the NetStream function is disabled in inbound and outbound directions.
The NetStream function supports the collection of statistics about inbound and outbound packets
separately.
Step 4 (Optional) Run:
ip netstream suppress suppress-rate { inbound | outbound }
The suppression ratio of the packets on the interface is set.
By default, the suppression ratio on interfaces is 1000.
The suppression ratio is used for traffic sampling. After the suppression ratio is set, the
S9300&S9300E does not sample the packets that are filtered out in the suppression.
Step 5 (Optional) Run:
ip netstream sampler fix-packets packet-interval { inbound | outbound }
The fixed-packets sampling ratio on the interface is set.
By default, the fixed-packets sampling ratio on an interface is 1000:1.
----End

7.5.3 (Optional) Configuring the Version of Exported Packets

Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2012-03-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
Data
IP addresses and port numbers of the NSC
512

Advertisement

Table of Contents
loading

This manual is also suitable for:

S9300e

Table of Contents