Starting The Test Instance - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The test instance view is displayed.
Step 3 Run:
test-type { dhcp | dns | ftp | http | icmp | jitter | lspjitter | lspping |
lsptrace | snmp | tcp | trace | udp | pathmtu | pwe3trace | pwe3ping | macping |
mactnlping | icmpjitter | pathjitter | mping | mtrace | vplsping | vplstrace |
vplsmping | vplsmtrace}{ dhcp | dns | ftp | http | icmp | jitter | lspjitter |
lspping | lsptrace | snmp | tcp | trace | udp | pathmtu | pwe3trace | pwe3ping |
macping | mactrace | icmpjitter | pathjitter | mping | mtrace | vplsping |
vplstrace | vplsmping | vplsmtrace | vplspwping | vplspwtrace | gmacping |
gmactrace }
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
alarm entry-number { lost-packet-ratio | jitter-average | jitter-ds-average |
jitter-sd-average | packet-loss-ds | packet-loss-sd | rtt-average } { absolute |
delta } { falling-threshold threshold-value1 event-entry1 | rising-threshold
threshold-value2 event-entry2 } * [ description description ]
The alarm number and the threshold are configured.
----End

6.33.4 Starting the Test Instance

You can start a test instance. When the number of test results exceeds the threshold,
corresponding action is taken.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
Issue 01 (2012-03-15)
NOTE
At present, only the absolute statistics function rather than the relative statistics function is supported.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
379