Configuring The Pwe3 Ping Test To Check The Multi-Hop Pw - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Run the display nqa results command to view the test results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l
l
l
<Quidway> display nqa results
NQA entry(admin, pwe3ping) :testflag is inactive ,testtype is pwe3ping
1 . Test 1 result
6.25 Configuring the PWE3 Ping Test to Check the Multi-
Hop PW
This section describes how to configure a PWE3 ping test to check the connectivity of a multi-
hop PW.
Issue 01 (2012-03-15)
Statistics about errors
– Number of unroutable connections
– Number of wrong sequence numbers
– Timeout times of the test packets
History statistics of each test packet
– Timestamp added when each test packet is sent
– Timestamp added when each test packet is received
– Packets status displayed on the NQA client
Statistics of results of each test
– Number of successful tests
– Sum of the response time of all tests
– RTT square sum
– Minimum RTT and maximum RTT of the packet
– Destination IP address and the type of the destination IP address
– Number of the Echo packets and the sent packets
– Time when the last packet is received
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:3.14.2.14
Min/Max/Average Completion Time: 6/6/6
Sum/Square-Sum Completion Time: 18/108
Last Good Probe Time: 2009-2-27 9:0:42.3
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
6 NQA Configuration
344