Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l Run:
l Run:
l Run:
----End

6.28.3 Checking the Configuration

After setting universal parameters for NQA test instances, you can view the test result.
Prerequisites
The configurations of the Universal NQA Test Parameters function are complete.
Procedure
Step 1 Run the display nqa-agent [admin-name test-name ] [ verbose ] to view the status of the test
instance configured on the NQA client.
----End
Example
<Quidway> display nqa-agent
NQA Tests Max:2000
NQA Flow
nqa test-instance a a
test-type pwe3trace
local-pw-id 1
vc-type bgp
nqa status : normal
nqa test-instance a b
test-type icmpjitter
destination-address ipv4 100.1.1.201
source-address ipv4 100.1.1.200
hardware-based enable
ttl 100
tos 100
Issue 01 (2012-03-15)
tracert-livetime first-ttl first-ttl max-ttl max-ttl
The lifetime is set for the Trace test instance.
NOTE
This parameter can be configured only for Trace, LSP Trace, MTrace and PWE3 Trace test instances.
vpn-instance vpn-instance-name
The VPN instance name is configured for the NQA test instance.
NOTE
This parameter cannot be configured for DNS, LSP Ping, LSP Trace, LSP Jitter, and PWE3 Ping test
instances. When the signaling protocol of the VC is BGP, this parameter can be configured for PWE3
Trace test instances.
vc-type { ldp | bgp }
The signaling protocol type is configured for the L2VPN VC.
NOTE
This parameter can be configured only for PWE3 Ping and PWE3 Trace test instances. In the case of
the PWE3 Ping test instance, this parameter can be configured only when the signaling protocol is
LDP.
Max:1000
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
NQA Tests Number:
NQA Flow Remained:1000
6 NQA Configuration
2
362