Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The FTP password used during the login is configured.
Step 9 Perform the following as required to upload the file.
l To upload the file with a specified name, run the ftp-filename file-name command.
l To upload the file with a specified size, run the ftp-filesize size command. The client then
Step 10 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.7.3 Checking the Configuration

After configuring the FTP upload test, you can view the test result.
Prerequisites
The configurations of the FTP Upload Test function are complete.
Issue 01 (2012-03-15)
NOTE
l If no file path is specified, the system searches for the file in the current path. If the specified file
name does not exist, a file is created according to the specified file name, and the size of the file is
set to 1 MB.
l The file name cannot contain characters such as ~, *, /, \, ', ", but the file path can contain these
characters.
l The file name can contain the extension name but cannot contain the extension name only, such
as .txt.
automatically creates a file name "nqa-ftp-test.txt" to upload.
NOTE
During the FTP test, select a file with a relatively small size. If the file is large, the test may fail because
of timeout.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
271