Huawei S9300 Configuration Manual page 321

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Context
Do as follows on the ingress of an LSP tunnel:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type lspjitter
The test type is set to LSP Jitter.
Step 4 Run:
lsp-type ipv4
The tunnel type is set to be the LSP tunnel.
Step 5 Run:
destination-address ipv4 ip-address { lsp-masklen masklen | lsp-loopback loopback-
address }*
The destination IP address of the LSP Jitter test is configured.
Step 6 (Optional) Perform the following as required to configure other parameters for the LSP Jitter
test:
l To configure a protocol used by the LSP ping test, run the lsp-version { rfc4379 | draft6 }
l To configure the next-hop IP address in the scenario where load balancing is enabled on the
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the packet size, run the datasize size command.
l To configure the maximum TTL value of the packet, run the ttl number command.
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure the padding character of the packet, run the datafill fillstring command.
l To configure the interval for sending the test packets, run the interval seconds interval
Issue 01 (2012-03-15)
command.
initiator of the LSP ping test, run the lsp-nexthop nexthop-ip-address command.
NOTE
The next-hop IP address can be configured only when lsp-type is IPv4 and lsp-version is RFC 4379.
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
NOTE
In a uni-directional LSP Ping test, if the lsp-replymode no-reply command is configured, the test
result displays that the test fails regardless of whether the test, actually, is successful or fails. If the test
is successful, the test result also displays the number of the timeout packets. If the test fails, the test
result displays the number of the discarded packets.
command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
306