Huawei S9300 Configuration Manual page 405

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch and HTTP Server. The configuration details are not
mentioned here.
Step 2 Enable the NQA client and create an NQA HTTP test.
<Quidway> system-view
[Quidway] nqa test-instance admin http
[Quidway-nqa-admin-http] test-type http
[Quidway-nqa-admin-http] destination-address ipv4 10.2.1.1
[Quidway-nqa-admin-http] http-operation get
[Quidway-nqa-admin-http] http-url www.huawei.com
Step 3 Perform the test.
[Quidway-nqa-admin-http] start now
Step 4 Verify the test result.
[Quidway-nqa-admin-http] display nqa results test-instance admin http
NQA entry(admin, http) :testflag is inactive ,testtype is http
1 . Test 1 result
----End
Configuration Files
Configuration file of Switch
#
sysname quidway
#
vlan batch 10
#
Issue 01 (2012-03-15)
Configure the Switch as the NQA client.
Create and perform the HTTP test on the Switch to check whether the a connection between
the Switch and the HTTP server can be set up and to check the time for transferring a file
between them.
Host address of the HTTP server
HTTP operation type
The test is finished
SendProbe:3
Completions: success
MessageBodyOctetsSum: 0
DNSQueryError number: 0
TcpConnError number : 3
DNSRTT Sum/Min/Max:0/0/0
TransactionRTT Sum/Min/Max: 11/3/4
RTT Sum/Min/Max/Avg: 18/5/7/6
DNSServerTimeout:0 TCPConnectTimeout:0
Lost packet ratio:0%
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:3
RTD OverThresholdsnumber: 0
TargetAddress: 10.2.1.1
HTTPError number: 0
System busy operation number:0
TCPConnectRTT Sum/Min/Max: 0/0/0
TransactionTimeout: 0
6 NQA Configuration
390