Example For Checking The Rpf Path From The Source To The Switch Through The Mtrace Test - Huawei S9300 Configuration Manual

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

6.35.17 Example for Checking the RPF Path from the Source to the

switch Through the MTrace Test

Networking Requirements

all Switches to make Switches work synchronously, receiver is added to the multicast group

225.1.1.1 and receives multicast data from Source normally. This test is performed to check how

the traffic is transmitted to the RTB from Source along the RPF route.

You need to enable MTrace on Switch B to check the RPF path from the multicast source to the

current Switch.

The NQA MTrace test is used to implement the MTrace function.

Figure 6-19 Networking diagram of MTrace

Issue 01 (2012-03-15)

ip address 10.1.1.2 255.255.255.0

interface GigabitEthernet1/0/0

port hybrid pvid vlan 10

port hybrid untagged vlan 10

6-19, on the PIM-SM multicast network, implement the NTP protocal on

Huawei Proprietary and Confidential

6 NQA Configuration