Configuring The Mac Ping Test; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.15 Configuring the MAC Ping Test

This section describes how to perform the MAC ping test with NQA.

6.15.1 Establishing the Configuration Task

Applicable Environment
After you configure the MAC ping test, you can check the connectivity between two or more
devices by using the LBM and LBR packets defined by 802.1ag and collect statistics.
Pre-configuration Tasks
Before configuring the MAC ping test, complete the following task:
l
Data Preparation
To configure the MAC ping test, you need the following data.
No.
1
2
3
4
Issue 01 (2012-03-15)
Min Negative SD:1
Max Negative SD:20
Negative SD Number:18
Negative SD Sum:163
Negative SD Square Sum :2519
Min Delay SD:0
Avg Delay SD:3
Max Delay SD:49
Delay SD Square Sum:4
Packet Loss SD:0
Packet Loss Unknown:0
Average of Jitter SD:1
jitter out value:0.5599658
NumberOfOWD:60
OWD SD Sum:4
ICPIF value: 0
TimeStamp unit: ms
Packet Rewrite Ratio: 0%
Packet Disorder Ratio: 0%
Fragment-disorder Ratio: 0%
Enabling connectivity fault management (CFM) globally so that the maintenance
association end points (MEPs) of the same level can reside on the same VLAN
Data
Manager and name of the NQA test instance
Destination MAC address or REMP ID for the NQA test instance
Maintenance domain (MD) and maintenance association (MA) of the NQA test
instance
Starting and ending modes of the NQA test instance
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Min Negative DS:1
Max Negative DS:10
Negative DS Number:8
Negative DS Sum:28
Negative DS Square Sum :194
Min Delay DS:0
Avg Delay DS:3
Max Delay DS:48
Delay DS Square Sum:1
Packet Loss DS:0
Average of Jitter:1
Average of Jitter DS:1
jitter in value:0.3574005
Packet Loss Ratio: 0%
OWD DS Sum:1
MOS-CQ value: 0
Packet Rewrite Number: 0
Packet Disorder Number: 0
Fragment-disorder Number: 0
6 NQA Configuration
295